Table of Contents
Advertisement
5. Make sure that the electrical power
circuit breaker is switched off or the
fuse removed.
NOTE -- Before connecting electrical
power to the unit, refer to nameplate
to verify the power requirements.
A. Remove the following:
– Top cover by removing
screws on the top and lifting
up
– key switch wires
B. First route the new cord up behind
the valve panel and through the
cutout in the deck. Use the
already attached wire tie/fastener
on the deck to secure the cord.
C. Connect cord to the receptacle on
the refrigeration deck.
D. Turn the circuit breaker on and
then the units power switch. Check
to see that the agitator motor has
started. After about three minutes
the compressor should start. If the
agitator or compressor do not start
call Technical Services.
- 11 -
Cord
Fastener
Plug cord into
Receptacle
Power
Switch
© 2010, IMI Cornelius Inc.
Advertisement
Table of Contents
