Cornelius Impulse XL Operator's Manual page 17

2. The unit has a built-in carbonator, connect the water line to the
pump.
3. Connect optional drip tray drain hose (if used). Be sure the
knock-out in the drip pan has been removed if drain hose is
used.
4. If the unit has a built-in carbonator,
connect the CO
sure the water and CO
CO should be set at 75 psi
2
(5.25 bar) maximum. Higher CO
pressure will result in LOWER
carbonation.
Bleed the air out of the carbonator
by pulling up on the metal ring on
the bleed valve. Bleed each valve into a bucket until water comes out
for 2-3 seconds.
lines. Be
2
are on.
2
2
- 13 -
Water Line Connected
to Pump
CO Inlet
2
(hold with wrench)
Carbonator
Bleed Valve
© 2010, IMI Cornelius Inc.