ALLIANCE 030 Series Installation Manual page 6

• Machinery Directive 2006/42/EC
• Gas Appliance Directive 2016/426/EU
• RoHS Directive 2011/65/EU and its amendment directives;
Commission Delegated Directive 2015/863 to restrict four
phthalates
If the product has telecommunications functionality, it also com-
plies with the requirements of the following EU directive:
• Radio Equipment Directive 2014/53/EU
Compliance with these Directives implies conformity to harmon-
ized European standards that are noted in the EU Declaration of
Conformity which is available upon request.
Alliance Laundry Systems products comply with the requirement
of Article 12 as it can be operated in at least one Member State as
examined and the product is compliant with Article 11 as it has
no restrictions on putting into service in all EU member states.
This device contains a 2.4GHz transceiver, intended for indoor
use only in all EU member states, EFTA states, and Switzerland.
Attention has been given to allowed operational frequencies. For
detailed information concerning installations in France, the user
should contact the national spectrum authority in France (http://
www.arcep.fr/ )
Be aware that outdoor installations require special attention and
will only be handled by trained and qualified installation person-
nel. No one from the general-public is permitted to install wire-
less products outdoors when external antennas, power and
grounding must be installed for use.
AUSTRALIA/NEW ZEALAND
The radio in this equipment complies with and is certified to the
Australian and New Zealand regulatory requirements.
BRAZIL ANATEL
This device is not entitled to protection against harmful interfer-
ence and may not interfere with duly authorized systems.
CHINA SRRC
The radio device has recieved certification of conformance in ac-
cordance with the People's Republic of China State Radio Regu-
lation Committee (SRRC) certification scheme. Integrations of
this radio into a final product does not require additional radio
certification provided installation instructions are followed. No
changes are authorized to the radio or the antenna of the ap-
proved device.
JAPAN
This product is equipped with a certified wireless device pursuant
to Article 2-1-19 of the Certification Ordinance. No changes are
authorized to the radio or the antenna of the approved device.
MEXICO IFETEL
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
"The operation of this equipment is subject to the following two
conditions: (1) it is possible that this equipment or device does
not cause harmful interference and (2) this equipment or device
must accept any interference, including that which may cause its
unwanted operation."
SOUTH KOREA (KC)
The radio device has received certification of conformance in ac-
cordance with the Radio Waves Act. Integration of this radio into
a final product does not require additional radio certification pro-
vided installation instructions are followed. No changes are au-
thorized to the radio or the antenna of the approved device.
TAIWAN
The information in this section applies to products bearing the
Taiwan National Communications Commission mark:
This telecom equipment has complied with NCC regulations.
According to "Administrative Regulations of Low Power Radio
Waves Radiated Devices:
Article 12 The low-power radio-frequency devices must not be
altered by changing the frequency, enhancing emission power,
adding external antenna, and modification of original design
characteristic as well as function.
Article 14 The operation of the low-power radio-frequency devi-
ces is subject to the conditions that no harmful interference is
caused. The user must stop operating the device immediately
should harmful interference is caused and shall not resume until
the condition causing the harmful interference has been correct-
ed.
Moreover, the interference must be accepted that may be caused
by the operation of an authorized communications, or ISM equip-
ment. (1) Precautions (marked in the product manual and on out-
er packaging)
THAILAND
The information in this section applies to products approved by
the Thailand National Communications Commission:
These telecommunication and device are compliance with the re-
quirements of National Broadcasting and Telecommunication
Commission.
Manufacturing Date
The manufacturing date for your unit can be found on the serial
number. The first two digits indicate the year. The third and
fourth digits indicate the month. For example, a unit with serial
number 1505000001 was manufactured in May 2015.
6 Part No. 70686701ENR4