ALLIANCE 030 Series Installation Manual page 37

1
5
4
1. Plug
2. Switch
3. Door Hinge Lug
4. Door Assembly
5. Side Screw
7. Cut wire ties to remove door switch harness bundle. Be care-
ful not to damage harness wires. Refer to Figure 10 .
8. Reroute door switch harness up through the hole in the right
side of the top panel. Use the panel cutout opening to then put
harness down through the hole in the left side of the top panel
and into the upper left corner of the cylinder enclosure.
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
2
3
TMB2101N_SVG
Figure 9
6
5
4
1. Beginning Location of Door Switch
2. Wire Ties
3. Original Switch Location
4. Original Plug Location
5. Top Panel
6. Panel Cutout
9. Place front panel on machine, loosely attach four bottom
screws. Connect door switch harness to switch in new loca-
tion. Install door assembly and four front panel side screws
loosely. Refer to Figure 11 .
10. Check lint panel fit, adjusting front panel up or down as re-
quired. Tighten four front panel side screws to maintain posi-
tion of front panel for proper lint panel clearance.
11. Remove lint panel. Fully tighten bottom screws on front pan-
el.
12. Reinstall top screws and guide lugs.
13. Adjust door catch if necessary to allow 8 – 15 pounds [35.6N
– 66.7N] pull at center of handle.
14. Reinstall control assembly using mounting screws.
15. Reinstall control panel and lint panel.
37
Installation
TMB2608N_SVG
Figure 10
Part No. 70686701ENR4
1
2
3