Demounting - Hunter TCX50 Operation Manual

Demounting

If the outer bead of the tire has "re-seated", or needs additional lubrication, the bead loosening
procedure can be repeated with the BP Bead Press Arm rather than the side shovel.
The BP Bead Press Arm can be used when removing the tire from the rim.
1- Position the mount/demount head on the tire and rim.
2- Insert bead lever.
The Bead Press Arm can also be used to create a gap for the bead lever.
3- Position the Bead Press Arm head approximately 180° from the mount/demount head.
4- Lower the Bead Press Arm head so the bead is pressed downward toward the center of
the rim.
5- Using the bead lever, pull the bead up and onto the mount/demount head.
6- Raise the Bead Press Arm up and out of the way.
7- Rotate clockwise
50
NOTICE
to complete the demounting procedure.
Operation Instructions for TCX50 Tire Charger