Hunter TCX50 Operation Manual page 32

Do not stand over tire during inflation.
Step down completely on the air inflation pedal (pedal on the left side of the base) to release a
high-pressure air blast through jets on the clamps to assist in seating the beads of the tire.
AIR-JET
FROM HERE
To increase the effectiveness of the inflation jets, always liberally lubricate beads
and raise the lower bead while activating inflation jets.
Step down partially on the pedal to inflate tire and seal beads with inflation hose. Frequently
stop to check bead seating pressure on gauge.
Do not exceed tire manufacturer's maximum pressure as stated on the sidewall of
the tire when seating beads.
Reinstall valve stem core into the valve stem after beads have been seated, and then inflate
tire to vehicle manufacturer recommended pressure.
Activate air inflation jets only when sealing bead.
Bleed air pressure from system before disconnecting supply line or other pneumatic
components. Air is stored in a reservoir for operation of inflation jets.
Only activate the air inflation jets if the rim securing device is locked in place and
the tire is properly clamped.
Operation Instructions for TCX50 Tire Charger
WARNING
NOTICE
WARNING
WARNING
37