For Plastic Heads; Set Position Of Plastic Mount/Demount Head On Hex Shaft - Hunter TCX50 Operation Manual

Figure below is a summary of the desired end result.

For Plastic Heads

Calibration will require the use of a 17-18 inch bare rim. Figure below is a summary of the
desired end result.

Set Position of Plastic Mount/Demount Head on Hex Shaft

1- Clamp a 17-18" rim without a tire on the tire changer turntable.
2- Loosen the head retaining bolt slightly so that the head is still attached.
44
HEX SHAFT
PIN
ADJUSTMENT
BOLTS
17-18"
Operation Instructions for TCX50 Tire Charger
HEAD
RETAINING
BOLT