Hunter TCX50 Operation Manual page 24

Always verify that all four clamps are on the rim before applying pressure to prevent
possible damage to the rim.
Plastic jaw covers may be used to help maintain rim protection when clamping externally.
Plastic covers also be used to prevent wheel slip.
Plastic jaw covers may be replaced periodically when worn by ordering kit RP11-8-11100358
which contains 2 sets of plastic covers.
This tire changer is equipped with an adjustable turntable ; there are two knobs that allow extended
clamping capacity up to 26 " (up to 26" clamping externally / up to 28" clamping internally).
- with the knobs facing outwards, we have a clamping capacity that goes from 10" to 22"
(clamping externally).
- with the knobs facing inwards we have a clamping capacity that goes from 14" to 26"
(clamping externally).
To get this feature, pull the knob and rotate to move through an angle of 180 °
(note: the pin knob must fit into the locking hole).
It is always necessary that the two knobs are in the same position with respect to center of the
turntable: both facing outwards (10"-22") or both facing inward (14"-26").
A mixed position, with a knob facing outwards and the other facing inwards, is not recommended.
24
NOTICE
2
1
Operation Instructions for TCX50 Tire Charger