GE PACSystems RSTi User Manual page 78

Chapter 4. PROFINET Network Adapter
In order to add IO modules in this node, right click on recently added network adapter node
and select "Change Module List"; a pop up window will open as shown below:
Figure 43: Change Module List
Now start adding the IO modules as per the physical setup; after you add all the desired IO
modules, select "OK".
To configure PROFINET network adapter configuration, right click on the PROFINET adapter
node and select "Configure", a window will open as shown below:
Figure 44: Configuring PROFINET Adapter
There are three tabs in this window IO Device Access point, STXPNS Parameters, and
GSDML details.
78 PACSystems* RSTi PROFIBUS and PROFINET Network Adapter–August 2013 GFK-2746B