Connecting The Device - PROEMION CANlink mobile 3000 Series Device Manual

5.2. Connecting the Device

WARNING
Overload damage due to malfunction.

Risk of severe or fatal injury.
* To limit power in the event of malfunction, secure the DC power supply circuit during installation
with an external 2 A fuse.
NOTICE
Risk of property damage.

* The device must be installed, connected, and commissioned by a qualified technician.
* Ensure the power supply is disconnected before connecting the device.
* Only use components from the launch kit or the accessories supplied. Refer to chapters
Kit and
NOTICE
Device defect due to power failure.
Destroyed hardware component on the device. Repair not possible.
Destroyed file system on the device. Repair by Proemion necessary.
* Permanently connect terminal 30 to steady power supply (vehicle battery) to ensure that the

required power management settings can be applied to the device in the right manner.
* Permanent disconnection from the power supply is only permitted when the device was set to
sleep mode before.
* Connect terminal 15 correctly and configure secure switching to sleep mode in the
management
* Do not disconnect the device from the power supply until it has completely switched to sleep
mode (all LEDs off).
If you have any questions or anything is unclear, please contact our support before getting started. See
Service and Support.
5.2.1. Power Supply
The main plug connector supplies the device with power. If you use the power supply unit from the kit, make sure you
use the country adapter for your country.
CANlink mobile 3000 Device Manual
Software and Accessories.
section of the device configuration.
Launch
Power