Mounting The Device - PROEMION CANlink mobile 3000 Series Device Manual

5.9. Mounting the Device

Below you will find instructions on how to mount the device.
To ensure the housing provides proper fire protection and to achieve the best possible reception of radio signals, make
sure you install the device in the correct position.
NOTICE
Risk of property damage.
* The device can be mounted with the plugs pointing to the left or right. Mounting with the plugs

pointing up is not permitted. Mounting with the plugs pointing down is not recommended due to
the risk of water ingress.
* Only mount the device in one of the installation orientations shown in this chapter.
* The device is protected against mechanical impacts according to class IK07 (IEC62262 impact
energy 2 joules). To achieve a higher class, you must provide external protection when installing
the device
NOTICE
Reduced antenna gain
Problems with the mobile network connectivity can be caused by an insufficient antenna setup.

* Do not extend the antenna cable.
* Only use the antennas which are supplied as accessories by Proemion.
* Change the mounting position of the CANlink mobile to reduce the distance between antenna
and the CANlink mobile or order an alternative antenna with longer antenna cable.
* In case of using the antenna supplied in the hardware kit: Ensure that the minimum bending
radius of the antenna cables is greater than 8 times the outer diameter.
INFORMATION
The mounting material is not included in the scope of delivery.
Optionally, you can use the MOUNTING SET M5 HOUSING GH1208 (part number 141000017).

The mounting set contains the following components:
* 2 socket-head screws DIN912 - M5 x 30 mm
* 4 lock washers M5, di/da = 5.3/9 mm
* 2 hexagon nuts DIN934 / ISO4032 - M5
CANlink mobile 3000 Device Manual