Cables - PROEMION CANlink mobile 3000 Series Device Manual

4.4. Cables

NOTICE
Malfunction of the device
Problems with the mobile network connectivity can be caused by an insufficient antenna setup
and bending radius of the cables.
Cables can be damaged.
Water penetration due to incorrect assembly of the cable and missing sealing.

* Assemble the cables in accordance with the recommendation of the manufacturer
* When mounting the device, please make sure that there is an adequate bending radius of the
cables
* Install strain reliefs for the cables
* Protect and fix the cables within the machine
* In case of using the antenna supplied in the Launch Kit: Ensure that the minimum bending
radius of the antenna cables is 8 times the outer diameter.
4.4.1. Start Cable / Main Plug Connector CANlink mobile 3600
The cable CLM3600 Starter Cable 6open 3dsub 1pw 2m (part number 136000202) must be used for the CANlink
mobile 3600 variants and is equipped with the following connectors and open individual wires:
• 1 micro timer II socket,14-pin, female
• 3 D-sub, 9-pin, female (CAN1 and CAN2)
• 1 power connector
• 6 open wires
Figure 14. Micro timer II socket (14-pin, female)
Table 24. Start cable for main plug connector
Pi Designation
n
1 Terminal 30 / V
CC
2 CAN3-Low
3 Terminal 31 / ground Green
4 Analog input 1
5 Analog input 2
6 Analog input 3
7 Digital output
CANlink mobile 3000 Device Manual
Color Description
White Power supply (steady plus vehicle battery)
Brown CAN, bidirectional
Power supply
Yellow I/O input
Gray I/O input
Pink I/O input
Blue I/O output