Lcd Sub-Frame - Sony Ericsson Z525i Working Instruction

5. Then apply pressure simultaneously to the two sides
for of the bezel for 5 seconds.
•
Perform sections 3.2.2 - 3.2.3 of the flip reassembly.

4.15 LCD Sub-frame

The removal and installation of this part is covered in the flip disassembly and reassembly
procedures. To remove this part, perform sections 3.1.1 – 3.1.3 of the flip disassembly. To install
this part, perform sections 3.2.1 - 3.2.3 of the flip reassembly. If the LCD sub-frame is being
replaced, a new receiver must be installed in the new LCD sub-frame before installing the new
LCD sub-frame on the flip assembly. Refer to the "Receiver Installation" section of this document
for instructions on how to install the receiver in the LCD sub-frame.
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
Working Instruction, Mechanical
52(115)