Sony Ericsson Z525i Working Instruction page 81

b. Using tweezers, obtain a liquid intrusion
NOTE!
c. Using the flat end of a pry tool, apply gentle
2. Orient the circuit board so the contact pads for the
system connector are towards you.
3. Orient the system connector relative to the circuit
board so that side of the system connector with the
row of small holes is towards you and the side of the
system connector with the row of contact pads that is
end user accessible is pointed away from the circuit
board.
4. Align the row of small holes in the system connector
with the row of contact pads on the circuit board and
push the connector onto the circuit board until it is
completely seated.
•
Perform all sections of the Base Reassembly Procedure.
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
indicator and place it so that its top and left
edges are aligned with the top and left edges of
the connector's upper surface.
Do not use your finger to apply pressure
to the liquid intrusion indicator. Using a
finger to apply pressure may cause
partial activation of the label.
pressure to the liquid intrusion indicator to
ensure a good adhesive bond to the system
connector.
Step-by-Step Instructions
Working Instruction, Mechanical
81(115)