Flip Screw Cover Installation - Sony Ericsson Z525i Working Instruction

4.16.2

Flip Screw Cover Installation

When a screw cover is removed, a new screw cover should always be used in the place of it.
Tools needed to perform the following steps:
NOTE!
1. Make sure the phone is open so that the keypad is
accessible.
NOTE!
NOTE!
2. Install a new screw cover over the exposed screw
that is beside the co-brand label area.
3. Using your thumb, apply pressure to the newly
installed screw cover so that a good bond forms
between the screw cover and the top of the screw.
•
No reassembly required.
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
A " * " beside a tool listed above indicates that the tool is not specifically called out in the
following instructions, but an operator may find it helpful to use that tool when performing some
steps of the following procedure.
Step-by-Step Instructions
Do not use a previously used screw cover.
The screw covers have a specific
orientation. The notch in the screw cover
should be aligned to the standoff in the
screw's recess hole.
Working Instruction, Mechanical
* Style 2A ESD tweezers
54(115)