Sony Ericsson Z525i Working Instruction page 44

5. Then apply pressure simultaneously to the two sides
of the bezel for 5 seconds.
6. Obtain a new SEMC icon, remove its adhesive
protection, and place the icon in its cavity in the new
outer flip cover.
NOTE!
7. Apply gentle pressure to the icon to ensure a good
adhesive bond to the outer flip cover.
8. With the exterior surface of the new outer flip cover
oriented towards you, locate the two round holes
below the Sony Ericsson logo.
9. Obtain a new rubber plug and orient it relative to the
external surface of the outer flip cover so that the end
of the plug with the hole in it is pointed away from
the outer flip cover.
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
Make sure to align the peg on the icon with
the corresponding hole in the icon cavity.
Working Instruction, Mechanical
44(115)