Co-Branded Bezel Installation - Sony Ericsson Z525i Working Instruction

4.14.2

Co-Branded Bezel Installation

A new co-branded bezel should be used when performing the following steps.
Tools needed to perform the following steps:
1. Orient the outer flip cover so that its outer surface is
towards you.
NOTE!
2. Obtain the appropriate co-branded bezel and remove
the protective film from its non-logo side.
NOTE!
3. With the adhesive side of the bezel towards the outer
flip cover, insert the bezel into its cavity in the outer
flip cover.
4. Apply pressure simultaneously to the upper and
lower ends of the bezel for 5 seconds.
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
Make sure outer flip cover's bezel cavity is
clean. Use alcohol and lint-free wipes to
clean the cavity if necessary.
Avoid getting dirt, oil, or finger prints on
the inside surface of the bezel's window.
Working Instruction, Mechanical
•
Lint-free wipes
51(115)