Side Key Flex Film Installation - Sony Ericsson Z525i Working Instruction

4.35.2

Side Key Flex Film Installation

If this part is being replaced, a new part should be used in the place of the old part when
performing the following steps.
Tools needed to perform the following steps:
NOTE!
NOTE!
1. Obtain the side key flex film assembly that will be
installed.
2. Gently fold the connection portion of the side key
flex film 180 degrees in the location shown so that
when released the connection portion is at a 90
degree angle to the rest of the flex film.
NOTE!
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
A " * " beside a tool listed above indicates that the tool is not specifically called out in the
following instructions, but an operator may find it helpful to use that tool when performing some
steps of the following procedure.
The phrase "pry tool" indicates that a nylon pointer, an orangewood stick, or a front opening tool
may be used during this procedure depending on the user's preference.
Step-by-Step Instructions
Do not apply excess pressure to the fold line
to avoid damaging to the traces in the flex
film.
Working Instruction, Mechanical
* Pry tool
93(115)