Main Flex Film Installation - Sony Ericsson Z525i Working Instruction

4.37.2

Main Flex Film Installation

If the main flex film is being replaced, a new part should be used in the place of the old part when
performed the following steps.
Tools needed to perform the following steps:
*
NOTE!
1. If a new main flex film is being installed:
a. Install a Teflon pad on the main flex in the
b. Fold the main flex film's extension that contains
c. Once the main flex film's extension that contains
NOTE!
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
Style 2A ESD tweezers
A " * " beside a tool listed above indicates that the tool is not specifically called out in the
following instructions, but an operator may find it helpful to use that tool when performing some
steps of the following procedure.
location shown.
the vibrator contact pads back onto the main flex
film so that the vibrator contact pads are
accessible and the features of the extension are
aligned with the corresponding features of the
main flex film.
the vibrator contact pads is correctly positioned,
lightly crease the fold where the flex film
extension bends back onto the main flex film.
To prevent damage to the flex film, do
NOT over crease the fold in the flex
film.
• Pry tool
Step-by-Step Instructions
Working Instruction, Mechanical
103(115)