1. From Scala2, click Menu
2. Right-click the IP address of the receiver at the bottom of the page, then click
Configure Receiver.
3. Click the name of the sensor in the system tree view.
4. In Sensor Options, click Configure in front of Echograms.
5. In NBTE Echograms Filter, select Echosounder and Interference Reduction
Medium or Echosounder and Interference Reduction High.
Here is an example of result when applying this filter:
1. Noisy echogram with default filter ( Echosounder and Interference Reduction Low)
2. With Echosounder and Interference Reduction High filter applied.
> Expert Mode and enter the password
Catch Navigator | V1 |
Maintenance and Troubleshooting
.
copernic
58