Maintenance And Troubleshooting; Charging The Sensor With The Dock - Marport CATCH User Manual

Maintenance and Troubleshooting

Read this section for troubleshooting and maintenance information.

Charging the Sensor with the Dock

Connect a sensor to one of the 4 charging connectors of the Dock to display its level of
charge.
• Make sure the Dock is connected to a power supply and turned on.
Warning: In case of water ingress in the product, do not charge it: battery may
vent or rupture, causing product or physical damage.
Note: For Dock products with serial number before DOC2107XXX: Do not leave
the sensors connected on a charger that is switched off. If the charger is not
connected to the mains voltage, the sensor switches on and this will drain the
battery.
Note: Avoid full discharges and charge the battery whenever possible, at any
battery level. Lithium-ion batteries do not have a charge memory, so they do
not need full discharge cycles.
1. Before charging the sensor: wash with fresh water and dry the sensor. This
prevent corrosion of the charging pins.
Important: Check that the charging pins are not damaged. If they are,
contact you local Marport dealer for replacement.
Catch Navigator | V1 |
Maintenance and Troubleshooting
49