Changing The Detection Threshold Of The Catch Sensor; Applying Offsets To Measurements - Marport CATCH User Manual

Threshold of the Catch Sensor
You can change the threshold at which the catch status becomes full when the cords are
pulled.
1. Go to Measurements page and click
2. Set a value below 75% if you want the catch status to become full when the cords
are not entirely extended.
3. Set a value above 75% if you want the catch status to become full only when the
cords are fully extended.
Important: For proper operation, do not set the percentage below 65%
or above 85%.

Applying Offsets to Measurements

You can apply offsets to temperature and depth measurements if the measured values
does not correspond to the environment of the sensor.
1. Go to Measurements page and click
offsets.
2. Enter a target value. Click
Changing the Detection
.
Catch Navigator | V1 | Sensor Configuration
next to Catch.
next to depth or temperature to apply
26