Marport CATCH User Manual page 15

Mosa2 opens automatically and the startup wizard is displayed. The LED on the
plug is solid blue.
3. Connect the three-pin plug to the sensor.
The LED on the plug blinks alternatively blue and green.
4. Wait a few seconds. The configuration page of the sensor is displayed on Mosa2.
The LED on the plug is solid green.
You can now configure the sensor.
Note: You can keep the Configuration Cable continuously connected by
USB, and virtually eject or connect it. When no sensor is connected to
the Configuration Cable, click Menu
Config Plug. When ejected, you come back to the discovery page. It stays
disconnected until you virtually connect to it or manually disconnect then
connect it.
> Eject Config Plug or Connect
Catch Navigator | V1 | Sensor Configuration
15