Configuring The Trawl Node - Marport CATCH User Manual

In case of water ingress in the sensor, alarms are displayed in Scala2 Virtual Charger
Room, in Mosa2 and on the charger plug when connected to the sensor.
• Mosa2 displays a dialog at the start of the application and warning icon in the
toolbar and diagnostic page:
• The charger plug displays a warning icon:
When the alarm appears, take the sensor out of water immediately and contact Marport
support.
Warning: In case of water ingress in the product, do not charge it: battery may
vent or rupture, causing product or physical damage.

Configuring the Trawl Node

You need to give a trawl node to the sensor. It is the number corresponding to the
position of the sensor on the trawl.
The trawl nodes corresponding to the positions on the codend are the following:
Trawl number Node numbers
Trawl 1 1 to 6
Trawl 2 101 to 106
Trawl 3 201 to 206
Trawl 4 301 to 306
Catch Navigator | V1 | Sensor Configuration
18