Configuring Measurement Sending Sequence - Marport CATCH User Manual

Recommended
uplink powers
33%
100%
4. In Refresh Rate, leave Fast selected.

Configuring Measurement Sending Sequence

You can configure the order and types of measurements (e.g. temperature, pitch, roll...)
sent to the receiver.
1. Press command + A or click Menu
2. In Communications page, click
Conditions
Works for most conditions.
◦ Sensor is far from vessel (e.g. more than 800 m depending
on conditions, high depth)
◦ High level of interferences
◦ Issues receiving data
◦ Low SNR
and click User Mode > Advanced
in Data Sequence.
Catch Navigator | V1 | Sensor Configuration
21