Maintenance Checklist - Marport CATCH User Manual

• Wash away mud or debris with warm water.
• Use Isopropyl alcohol to clean the end cap and transducer. Use a steel wool
pencil to clean the shoulder bolts, and very fine sandpaper (180 grit) to clean
between them.
Notice: Do not use highly abrasive materials or jet wash.
Notice: Special care should be taken with sensors and components
sensitive to mechanical shock or contamination.
Regularly clean the pull cord magnet or it may stop working: remove the metal disk
fixed on the housing and clean the magnet with a swab or Q-tip. See Replacing the Pull
Cords (on page 52) to know how to remove the components.
We recommend you to follow this maintenance schedule for better performance and to
avoid any trouble with the equipment.
Before use
After use
Between uses

Maintenance Checklist

Wash the sensor with fresh water.
When the sensor is not in use, store in a dry area,
without humidity, at a temperature between -10°
and 70 °C (14 to 158 °F).
Catch Navigator | V1 |
Maintenance and Troubleshooting
• Check that all attachment equipment are
not worn or torn. Replace when appropri­
ate.
• Check that the sensor is clean. See Clean­
ing the Sensor (on page 50) for clean­
ing procedures.
• Check the battery level 24 hours before use
and recharge if necessary.
51