The measured value becomes the same as the target value. The value of the offset
is displayed.
3. If you need to reuse offsets from a previous configuration, click
configuration file (*.A2C).
You can test the measures taken by the sensor (e.g. battery level, temperature, depth)
to check that there are no faults.
You can test the sensor in water or in air. In air, the following measures will be wrong:
height, conductivity.
1. Press command + A or click Menu
2. Go to the Monitoring page.
Testing Measures
and click User Mode > Advanced
Catch Navigator | V1 | Sensor Configuration
then select the
27