System Configuration and Display
Learn how to configure the receiver and display the sensor data in Scala2 application.
Adding the Sensors to the Receiver
You need to add the sensors to the receiver in order to display their data on Scala2.
Adding the Sensors to the Receiver
You need to add the sensors to the receiver using the system web page.
1. From Scala2, click Menu
2. Right-click the IP address of the receiver at the bottom of the page, then click
Configure Receiver.
3. From the left side of the receiver page, click Sensors.
4. From the page Add Sensor Product select:
a. Product Category: TE/Catch
b. Product Name: Catch Navigator
c. Trawl Gear Location: same as defined in Mosa2 (see Configuring the
Trawl Node (on page 18)).
> Expert Mode and enter the password
Catch Navigator | V1 | System
Configuration and Display
.
copernic
37