Replacing The Catch Magnet - Marport CATCH User Manual

Only qualified Marport technicians can do this task.
1. Remove the old pull cords.
2. Install the new pull cords.

Replacing the Catch Magnet

You can replace the magnet that is part of the pull cord assembly when the magnet is
broken.
For this task you need the following tools:
About this task
Procedure
a. Remove the four screws on the pull cord assembly with a
9/64 size Allen key.
b. Remove the cords, spring and magnet from the hole.
a. Install the new pull-cord assembly on the side or on the
end cap of the sensor.
b. Apply anti-seize on the four screw threads, then tighten the
screws with the 9/64 size Allen key.
Before you begin
Catch Navigator | V1 |
Maintenance and Troubleshooting
53