IBM WebSphere DataPower 7198 Installation And User Manual page 56

RAID battery backup status
Other sensors
36
Installation and User's Guide
Monitors the battery backup unit on the RAID controller.
From the WebGUI, click STATUS → System → RAID Battery Backup
Status.
From the command line, enter show raid-battery-backup.
Provides truth values for the intrusion switch, power supply modules,
batteries, and the hard disks.
v A value of true indicates that the condition exists.
v A value of false indicates that the conditions does not exist.
For the intrusion switch, the value indicates whether it has been tripped.
v For each power supply, the value indicates the condition:
– Output Failure
– Present
v For each hard disk in the array and the battery, the values indicates the
state:
– Fault
– Present
Note: The hard disk drive modules are not hot-swappable. Hot
swapping the modules will cause your system to crash, and could
possibly damage your appliance.
v From the WebGUI, click STATUS → System → Other Sensors.
v From the command line, enter show sensors-other.