Removing And Replacing Cru Parts - IBM WebSphere DataPower 7198 Installation And User Manual

2. Perform a graceful shutdown by pressing the power button on the front of the
Before proceeding, verify that the power LED is not illuminated.

Removing and replacing CRU parts

Replacement of Tier 1 CRU parts is your responsibility. If an IBM representative
installs a Tier 1 CRU part at your request, you will be charged for the installation.
Use the following hardware maintenance procedures to remove and replace a CRU
part when directed by IBM Support:
v "Replacing a fan module" on page 49
v "Replacing a power supply module" on page 51
v "Replacing a hard disk drive module" on page 53
v "Replacing an Ethernet module" on page 56
v "Removing an SFP transceiver" on page 58
48
Installation and User's Guide
From the command line
Use the write memory command
chassis. Because the appliance does not provide feedback of a graceful
shutdown, wait until the power LED is no longer illuminated.