Procedure 4 Of 4: Accepting The License Agreement; Completing The Configuration - IBM WebSphere DataPower 7198 Installation And User Manual

Next step: Accept the license agreement and verify the base configuration. See

"Procedure 4 of 4: Accepting the license agreement."

Procedure 4 of 4: Accepting the license agreement
You need to access the WebGUI and accept the license agreement. If you can access
the WebGUI, the initial base configuration has network connectivity.
Before you begin: Create additional administrators who can reset passwords. See
"Procedure 3 of 4: Creating users who can reset passwords" on page 28.
This procedure makes the following assumptions:
v The IP address for the Ethernet interface is 10.10.13.35
v The specialized HTTP server to support WebGUI access listens on port 9090
To access the WebGUI from any browser:
1. Open the web browser.
2. In the Address field, enter https://10.10.13.35:9090.
3. Log in to the appliance with the local administrator account and password.
4. Click Login. The WebGUI displays the license agreement.
5. Log in again to verify that the admin account and additional administrators can
Next step: Complete the configuration on the appliance by creating application
domains and user groups for service development. See "Completing the
configuration."

Completing the configuration

Configuration beyond the base configuration is outside of the scope of this
document.
v Use the administration documents to complete the configuration of your
v Use the development documents to create the services in the application
To access this documentation, see access the version- and product-specific
information center from the DataPower documentation portal.
If the web page displays successfully, the base firmware configuration is
successful.
v Click I agree to accept the terms of the license agreement and non
IBM-terms. The appliance reloads the firmware. In a few minutes, you can
log in again after the appliance restarts.
v If you do not agree, click I do not agree. The initialization of the appliance
stops. You need to either power off the appliance or review and accept the
license agreement.
access the appliance with their credentials.
DataPower appliance.
domains of your DataPower appliance.
http://www.ibm.com/software/integration/datapower/library/
documentation
Chapter 4. Setting up the initial firmware configuration
29