IBM WebSphere DataPower 7198 Installation And User Manual page 40

To install the appliance on the slide rails, complete the following steps as shown in
Figure 13.
1. Pull the slide rail forward 1 .
2. Use two people to carefully lift the appliance 2 and tilt it into position over
3. Slide the appliance down until the rear nail heads slip into the two rear slots,
4. Make sure that the front latch 6 slides over the nail heads.
Figure 13. Secure the appliance in the rack
5. If the appliance is locked into place, slide the appliance toward you so that you
6. Slide the appliance into the rack, as shown in Figure 14 on page 21.
20
Installation and User's Guide
> 18 kg (39.7 lb)
the slide rails so that the rear nail heads 3 on the appliance line up with the
rear slots 4 on the slide rails.
and then slowly lower the front of the appliance 5 until the other nail heads
slip into the other slots on the slide rails.
can attach the brackets with the captive screws.
Lift point
Lift point