Maintenance; Lubrication; Safety - DAL-BO Dinco 2000 Manual

Lubrication

Safety

Ñ
Page 16

Maintenance

Proper maintenance lengthens the life span of the Dinco and thus secures
optimal utilisation of the implement. For that reason grease nipples have been
placed where the most wear happens.
All nuts and bolts should be tightened up after the first day. Pins and bolts
should be checked to avoid damage.
Depending on the model a different number of lubrications points exists which
need lubrication after 50 hours work. The lubricating nipples by the tines,
however, should be lubricated daily.
· (A) Roller bearings (50-hour-lubrication interval)
· (B) Disc bearings (50-hour-lubrication interval)
· (C) Spindle (lubricate as required)
· (D) Lubricating nipple for the pin in the bottom of the cylinder (daily)
· (E) Lubricating nipple for the pin in the eye of the cylinder (daily)
· (F) Lubricating nipple for the pin in the tine holding plate (daily)
Fig. 10
D
It is very dangerous to stay under Dinco when it is lifted without proper
support. At the same time the tractor should be properly braked and the engine
switched off.
Dinco
B
A
E
C
F