Hydraulics; Assembly; Maintenance And Repair; Road Transport - DAL-BO MaxiCut 200 Instruction Manual

Hydraulics

• Lower machine fully for any repair work on the hydraulic system. Relieve
• Clean hydraulic connections thoroughly before reconnecting. When con-
• Bleed the hydraulic system thoroughly after any repairs.
• Check hydraulic hoses regularly for defects such as cracks, splits, crimps,
• Avoid spilling oil on the ground. If oil is spilt, collect and deliver to a de-
• Clean hands thoroughly after contact with oil and grease. Change oil-
• Hydraulic oil released under high pressure can penetrate the skin and

Assembly

Maintenance and repair

• Ensure machine is adequately supported or fully extended for all repair
• Tighten all screw connections after a few hours use. Check all screw con-
• Dispose of oil, grease and filters in accordance with local environmental

Road transport

• All safety and warning precautions mandatory by law must be fitted and
Side 8
hydraulic pressure, switch engine off and remove ignition key.
necting hydraulic hoses to tractor hydraulics, ensure they are not under
pressure.
wear or breaks. Defective hoses must be replaced immediately.
struction point.
stained clothing immediately. Hydraulic oil can be harmful to the skin.
cause severe injury. In the event of injury, seek medical help immediately.
• Danger of crushing! Ensure no personnel are between implement and
tractor, or between the parts to be connected.
and maintenance work. Ensure tractor and machine are properly braked,
engine stopped and ignition key removed.
nections regularly and tighten as required. Check all split pins and bolts to
avoid mechanical failure.
protection rules.
tested before transporting the machine on public roads. The driver is re-
sponsible for fitting the correct lighting and number plate required in ac-
cordance with applicable legislation.
MaxiCut