Table of Contents
Advertisement
Dinco
Mounting of accessories
Depending on the type of rear roller (packer roller or t-rings) two different
bearings for the crumbler exists.
Fig. 12
A
T-rings
The crumbler for the t-ring roller is mounted with 4 16x50 mm. bolts, which
are fitted in the flanges (A, fig. 12) at the very back of the bearings for the rear
roller. The adjustment bolts (A, fig. 13) should be screwed in completely to
facilitate the mounting. Fine adjustment of the crumbler is done on the basis
that the adjustment bolts have been screwed in completely.
Fig. 13
A
D
B
C
Packer roller
As packer rollers come with no scrapers bearings (B, fig. 13) should be
mounted before the crumbler can be mounted.
1. Mount the adjustment bolt (A) and screw it all the way in.
2. Mount the rotation stand (C, fig. 13) on the bearing (B, fig. 13), please
remember the washer and split pin.
3. Bolt the rotation stand to the bearing of the rear roller (D, fig. 13).
4. Mount the flange bearings loosely on the crumbler shaft
5. Roll the crumbler in between the bearings (B, fig. 13).
6. Bolt the flange bearings to the bearing.
7. Secure the pointed screws with Locktite and tighten them.
Page 19
Advertisement
Table of Contents
