Table of Contents
Advertisement
Proper maintenance ensures a long lifetime for the Frontflex 2000 and also
optimum performance from the implement. To facilitate maintenance, grease
fittings (A) have been mounted on those locations where wear on the equip-
ment is the greatest.
Fig. 6
Lubricate the bearings near the rings every 50 hours of operation. Do not over
lubricate since this will destroy the seals.
The top piece will slide best if the nylon rail is clean and free of oil. There-
fore, do not lubricate the nylon rail. Lubricants can collect dirt and grit which
may cause excessive wear.
Ñ
Tighten all nuts, bolts or any other fastened assemblies after a few hours' use.
Check often to make sure that they remain thoroughly tightened. Inspect all
pins, screws and bolts for wear or damage and make sure that all are securely
in place to avoid any possible damage or breakdown of the machine.
Avoid spilling oil on the ground. In case of spills, collect the oil and dispose
of it properly.
Ñ
In case skin should come in contact with oil or grease or in case clothing
should become stained with oil, remove the stained clothes immediately and
wash the affected skin areas thoroughly. Oil and grease are harmful to the
skin.
Maintenance
Lubrication Points
Bearings
Frontflex 2000
A
Number of Fittings
2
side 11
Advertisement
Table of Contents
