Advertisement

Quick Links

Maxiroll Greenline
Lift 300
EN
Maxiroll Greenline Lift 300
Serial no.: 103 - XXX

Advertisement

Table of Contents
loading

Summary of Contents for DAL-BO Maxiroll Greenline Lift 300

  • Page 1 Maxiroll Greenline Lift 300 Maxiroll Greenline Lift 300 Serial no.: 103 - XXX...
  • Page 3 Congratulations on the purchase of your new Maxiroll Greenline Lift. For safety reasons and to achieve optimum performance from the product, please read the User Guide before use. © Copyright 2008. All rights reserved, DAL-BO A/S Your Maxiroll Greenline Lift has: ________________ Type no.: Serial no.:...
  • Page 5: Table Of Contents

    Table of Contents SAFETY .......................... 7 ..........................ENERAL .......................... YDRAULICS ..........................SSEMBLY MAINTENANCE AND REPAIRS ............................................ OAD TRANSPORT CORRECT USE ............................TECHNICAL DATA ....................10 HOW TO USE THIS MANUAL ................. 11 ..........................ELIVERY LIMITATIONS TO USE ........................USES ..........................13 CONNECTING AND DISCONNECTING ...............
  • Page 6 Retrofitting ......................23 MAINTENANCE ......................25 ........................UBRICATION ADJUSTMENT ........................Sowing wheel (accessory) ..................26 Scraper ........................26 ......................... YDRAULICS REPLACEMENT AND REPAIRS ................27 ......................... YDRAULICS Replacement of cylinder for extending and retracting sowing wheel (accessory) .. 27 REMOVING STEEL ROLLER ......................
  • Page 7: Safety

    Maxiroll Greenline Lift Safety This symbol appears in the instruction manual each time there is a safety warning concerning your safety, the safety of others or functionality of the machine. All safety instructions must be observed and made available to all users of the machine. General ...
  • Page 8: Hydraulics

    Maxiroll Greenline Lift Hydraulics  Lower machine fully for any repair work on the hydraulic system. Relieve hydraulic pressure, switch engine off and remove ignition key.  Clean hydraulic connections thoroughly before reconnecting. When connecting hydraulic hoses to tractor hydraulics, ensure they are not under pressure.
  • Page 9: Road Transport

    Maxiroll Greenline Lift Road  All safety and warning precautions mandatory by law must be fitted and transport tested before transporting the machine on public roads. The driver is responsible for correct lighting and warning signs in accordance with traffic regulations. ...
  • Page 10: Technical Data

    Maxiroll Greenline Lift Technical data Maxiroll Greenline Lift 300 Table 1. Width (cm) Min. HP/KW (recommended) Min. 85/62 Accessories Levelling bar (kg) Harrow section with crackerboard (kg) Harrow section (kg) Grass sowing system Sowing wheel (kg) 95-120 Ladder (kg) Light (kg)
  • Page 11: How To Use This Manual

    Maxiroll Greenline Lift How to use this manual The sequence of subject matter in this manual can seem illogical. Please refer to the table of contents for page numbers for individual items. The manual is divided into 5 main sections: ...
  • Page 12: Limitations To Use

    Maxiroll Greenline Lift Limitations to use The following describes what the machine can and cannot be used for:  Can only be used for levelling, aeration and sowing on agricultural land under cultivation. Fields on which the machine is used must be in a good state of agricultural maintenance, i.e.
  • Page 13: Uses

    Maxiroll Greenline Lift 300 The levelling bar is mainly used for levelling molehills etc., to avoid soil and other materials getting into silage for example. The harrow aerates the soil by removing old grass from the roots. It can also be used for levelling molehills or to prepare soil for sowing/maintaining grass.
  • Page 14: Connecting And Disconnecting

    Maxiroll Greenline Lift Connecting and disconnecting Connecting Fig. 2 1. The machine is connected to the tractor lift arms (A). 2. Connect the top arm (B). 3. Raise the support leg (C).  Remember to secure using split pins or the like. ...
  • Page 15: Setting Up

    Maxiroll Greenline Lift Setting up Maxiroll Greenline Lift is supplied with factory settings, but fine adjustment will always be required before use. Numerous adjustment options make the Maxiroll Greenline Lift more flexible and ensure maximum use. Adjusting drawbar height To achieve uniform rolling, the tube (A, Fig. 3) on the frame must be parallel with the ground (B).
  • Page 16: Filling Water

    Maxiroll Greenline Lift Filling water Fig. 4 Turn roller until plug (A) is at top. Turn roller until plug is at an angle relative to the ground to achieve desired level of water if a full roller is not required. ...
  • Page 17: Operation

    Maxiroll Greenline Lift Operation Correct operation is vital for optimum use of the machine. This applies to working in the field and for safety. Always ensure you are fully familiar with all safety aspects of the machine. Working position Tractor must be parked when preparing working position. ...
  • Page 18: Harrow Section

    Maxiroll Greenline Lift Harrow section Fig. 9 To adjust the angle of operation of the harrow section, push handle (D) forwards or backwards to the desired position. Fig. 10 Levelling board If a levelling bar is fitted, height can be adjusted at position (E). Fig.
  • Page 19: Transport Position

    Maxiroll Greenline Lift Fig. 13 Fig. 14 Sowing wheel If sowing equipment is fitted (accessory), there will be castor wheel included that can either run on the roller or the ground. Adjust height of the wheel bracket (K) before use. The bracket has a series of holes for height adjustment.
  • Page 20: Operating Speed

    Maxiroll Greenline Lift Operating An operating speed of 6-8 kph is recommended, but always operate according speed to conditions. Power Power requirement will depend on soil type, terrain and speed. Page 20...
  • Page 21: Troubleshooting

    Maxiroll Greenline Lift Troubleshooting Table 2. Fault Cause Remedy  Hoses not in coupling.  Fit hydraulic hoses correctly in Hydraulics not working (sowing tractor coupling. wheel).  Pilot operated non-return  Remove valve and clean parts.  Replace valve. (see "maintenance valve defective.
  • Page 22: Accessories

    Maxiroll Greenline Lift Accessories Maxiroll Greenline Lift can be fitted with a range of accessories to suit requirements. Fig. 16 Sowing wheel on steel Sowing wheel roller Sowing equipment on ground Light Harrow Levelling board Crackerboard Fig. 17 Steel roller or Cross-Combi ring Levelling board The advantage of the levelling bar is that it is mounted directly on the harrow section, allowing it to follow the ground contours.
  • Page 23: Crackerboard

    Maxiroll Greenline Lift  By moving the minimum amount of soil, fuel consumption is reduced significantly along with wear and tear. Crackerboard The crackerboard is a flexible unit with a range of uses. At a depth setting of 5 cm, the vibrating effect of the teeth will crush clumps. The CB tines are pretensioned to prevent vibration during operation.
  • Page 24 Maxiroll Greenline Lift Fit forward-acting arms (A) first. Push harrow frame (B) under main frame and secure on arms. (A) For more details, see spare parts drawing. Page 24...
  • Page 25: Maintenance

    Maxiroll Greenline Lift Maintenance Good maintenance ensures long service life and optimum use. Grease nipples are fitted where wear is heaviest.  Tighten all screw connections after first working day. Check all split pins and bolts to avoid mechanical failure. Check hydraulic system for leaks. Lubrication Fig.
  • Page 26: Adjustment

    Maxiroll Greenline Lift Adjustment Sowing wheel (accessory) Lubricate and adjust wheel bearings at least once annually. Check tyre pressures (see recommended pressure on tyre). Adjustment and lubrication of wheel bearings 1. Remove hub caps. 2. Remove split pin. 3. Tighten castle nut 1/6th of a turn until hole aligns with axle. Turn wheel, check for resistance.
  • Page 27: Replacement And Repairs

    Maxiroll Greenline Lift Replacement and repairs  Safety is vital for all repair work on the machine. Always observe the following points, plus those under Safety First in the instruction manual.  When replacing cylinders, always fill new cylinder with oil before pressurising system.
  • Page 28: Removing Steel Roller

    Maxiroll Greenline Lift Activate extend/retract cylinders after fitting until they show a little movement. Reverse cylinders until they return to start position. Move cylinders backwards and forward several times. Ensure no personnel are within the extension radius of the side sections. Removing steel roller Repairs must be performed with the machine connected to a tractor, resting on a level surface, fully extended with the roller resting on the ground.
  • Page 29: Scrapping

    Maxiroll Greenline Lift Scrapping Machine must be lowered. It is essential that all cylinders (accessories) are depressurised. Disconnect hydraulic hoses and cylinders and drain oil. Collect oil in container to avoid pollution. Send oil and hoses for destruction. All iron used in the machine can be recycled. Page 29...
  • Page 30: Hydraulics Diagram

    Maxiroll Greenline Lift Hydraulics diagram Fig. 25 21205 Double non-return throttle valve Page 30...
  • Page 31: Spare Parts

    Maxiroll Greenline Lift Spare parts Page 31...

Table of Contents