Connecting And Disconnecting; Connecting; Hydraulics; Disconnecting - DAL-BO Dinco 2000 Manual

Connecting

Ñ
Please remember to secure the lift arms and the levelling bar connections with

Disconnecting

Handling without three-point hitches

Connecting and disconnecting

Dinco is constructed according to the DS/ISO 730-1 category II and III. If the
lift construction on the tractor is not designed for this, please contact your Dal-
bo agent.
First mount the lift arm with the lift pins. Then mount the levelling bar. Adjust
the levelling bar so that the frame is in a horizontal position.
split pins.

Hydraulics

Depending on the type of Dinco different requirements for hydraulic services
on the tractor are necessary.
· Hydraulically folding models require a double-acting service.
· Models with NSH require a single-acting service (
(Hydraulically folding models with NSH require only double-acting service
as the hydraulic hose for NSH can be dismounted after adjusting (see
"Adjustment"), whereupon hoses for folding and unfolding can be
connected to the double-acting service).
Connect the hydraulic hoses to the double/single-acting 1/2´´ socket situated
near the lift.
Disconnecting is done in reverse order than connecting. Please remember to
ease the pressure on the connection hose before the hydraulic hose is
disconnected. Furthermore the ball plug valve for hydraulic stone releasers
should be closed (see fig. 4).
If moving Dinco without the use of three-point hitches, it is recommended to
use straps in the main frame to keep Dinco in balance.

Total weight of the Dinco (kg.)

Type 260 cm.
D 1165
NSH 1165
H=Hydraulically folding
NSH=Non Stop Hydraulic (see fig. 8)
D=Shear bolt for stone release (see fig. 9)
Dinco
300 cm. 380 cm.
1250 1510
1250 1510
NSH=Non Stop Hydraulic
380 cm. 470 cm.
H H
2025 2285
2025 2285
).
560 cm.
H
2575
2575
Page 9