Replacing Hoses For Hydraulic Stone Breakaway; Replacing Cylinders For Hydraulic Stone Breakaway; Replacing Seals For Hydraulic Stone Breakaway - DAL-BO Dinco 2000 Manual

Table of Contents

Replacing hoses for hydraulic stone breakaway

Page 24

6. Mount the spring washers so that the spring effect is obtained. Mount the

first spring plate so the rest side turns towards the tine hole plate. Turn the

other two spring washers the other way.

7. Mount the washer (C) and tighten the bolt (B) with c. 40 Nm. Please

remember to secure the bolt with Locktite.

Connect the NSH-system to the single-acting service on the tractor to remove

the pressure from the system. Then open the shut up valve (see fig. 4) and set

the service on the tractor in floating position. The pressure on the system will

disappear as oil will leak back to the tractor. The pressure can be read on the

manometer at all times.

The defect hose can be removed and a new one can be mounted. To re-

establish system pressure see "Adjustment", "Non-Stop-Hydraulic".

Fig. 21

1. Support Dinco according to instructions with tines lifted from the ground.

2. Remove pressure from the NSH-system see "Adjustments", "Non Stop

Hydraulic".

3. Remove the t-piece from the coupling whereupon it can be removed from

the cylinder.

4. Pull the splitpins from the pins and remove the pins.

5. Mount the new cylinder and remount the pins and splitpins.

6. Mount the coupling with gaskets in the new cylinder and screw on the t-

piece.

For removing cylinder see "Replacing cylinder for hydraulic stone releaser".

Dinco

Table of Contents