Mounting - DAL-BO Dinco 2000 Manual

Ñ
Ñ
7. Clean all parts and check for chips, burrs etc. Check for corrosion around
the scraper ring (pos. 4) in the end cap. If corrosion is found it should be
removed.

Mounting

1. Mount new seals (pos. 1+3+4+6+8+9+11+12) in the end cap and the
piston.
2. Lubricate the thread on the end cap (pos. 10) and the cylinder tube (pos. 5)
with fat or oil.
3. Mount the end cap (pos. 10) on the piston rod (pos. 7).
4. Mount the piston (pos. 2) and remount the bolt. Secure it with Locktite
Please take care that the thread is completely clean and free of oil and other
impurities. Oil should not be used until 12 hours after using Locktite.
5. Lubricate the outermost seal on the piston touching the cylinder tube and
the inside of the cylinder tube with oil and push the piston rod into the
middle position.
6. Mount the end cap on the cylinder tube and tighten.
7. Mount the cylinder.
8. Mount the hoses. Please note that hoses are not squeezed and that all
connections are tight.
After the mounting of the cylinders lift and lower the side sections gently a
couple of times to remove air from the system. Side sections cannot be lifted
higher than 30-40 cm. from the ground so that the side sections can be lowered
safely to the same side from which they were lifted.
Persons should not be within the radius of action of the machine as it is
involves danger to life.
Dinco
Page 27