Table of Contents
Advertisement
A good maintenance secures a long life of the Levelflex 2000 and thereby al-
so a full benefit of the machine. Therefore, lubricator nipples (A) have been
placed on the spots where hard wear takes place.
Plate 8
Grease points (amount of nipples)
Solid model
Hydraulic model
The ball bearings near the rings are to be lubricated every 50th working hour.
Overgreasing must be avoided, since it might destroy the sealings.
Tighten up all the screw joints after the first day of work. Split pins and
screw bolts must be checked up on to avoid damage on the machine.
In general
If the nylon rail is clean and free of oil, a smooth slide of the top piece can be
achieved. Therefore, the nylon rail must not be lubricated, as it would only
increase the wear and collect dust (see plate 21).
∇
All screw joints must be checked frequently and tightened up whenever it is
necessary.
∇
Damaged hydraulic tubes must be replaced immediately. Leaks on tubes
might cause personal injury or damage on the machine.
∇
Clean your hands thoroughly if your skin has had contact with oil and grease.
Change oil soaked clothing immediately, because it has a harmful effect on
the skin.
Avoid spillage of oil on the ground. Nevertheless, if spillage should happen it
must be picked up and sent to destruction.
Levelflex 2000
Maintenance
B
A
A
2
6
C
B
C
x
x
2
4
side 11
Advertisement
Table of Contents
