Replacing Scrapers; Replacing Rear Roller; Replacing Disc Bearings; Replacing Bushings - DAL-BO Dinco 2000 Manual

Replacing scrapers

Replacing rear roller

Replacing disc bearings

Replacing bushings

1. Screw the adjustment bolts (A, fig. 13) all the way in.
2. Remove the bolts which fasten the rotation stand (C, fig. 13) and splitpin
and washer can be removed.
3. Mount the old rotation stand on the new scraper and mount in reverse
order.
When replacing the packer roller or t-rings follow the same procedure as when
replacing bearings. Old bearings can be used, however, new ones are
recommended.
Fig. 19
Disc bearings are changed together with the shank as one unit.
1. Remove the bolts that fasten the shank stand to the frame, the discs and
spindle are now disengaged from the frame.
2. Remove the bolts that fastens the shank and the spindle and the telescopic
piece can be dismantled.
3. Mount a new shank with bearings and assemble in reverse order.
If play arises in the tine hole plate (A) it is a sign of worn down bushings.
Fig. 20
B
D
C
1. Support Dinco according to instructions with tines lifted from the ground.
2. Remove bolt (B).
3. Remove the washer (C) and the spring washers (D) from the pin and
remove the pin. Please note how the spring washers are mounted.
4. Pull or knock the bushings out.
5. Mount the new bushing. Then mount pin and tine hole plate. Please
remember to mount the pin from the side where the pin stop sits.
Dinco
A
Page 23