JETWAY MM10-H6100 Technical Manual page 37

Stop Bits
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
 USB Configuration
Press [Enter] to make settings for the following sub-items:
USB Configuration
XHCI Hand-off
This is a workaround for OSes without XHCI hand-off support. The XHCI
ownership change should be claimed by XHCI driver.
The optional settings are: [Enabled]; [Disabled].
USB Mass Storage Driver Support
Use this item to enable or disable USB mass storage driver support.
The optional settings are: [Disabled]; [Enabled].
USB hardware delays and time-outs
USB Transfer time-out
Use this item to set the time-out value for control, bulk, and interrupt transfers.
The optional settings are: [1 sec]; [5 sec]; [10 sec]; [20 sec].
Device reset time-out
Use this item to set USB mass storage device start unit command time-out.
The optional settings are: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. 'Auto' uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor.
The optional settings: [Auto]; [Manual].
Select [Manual] you can set value for the following sub-item:
Device Power-up delay in seconds
The delay range in from 1 to 40 seconds, in one second increments.
Use either [+] / [-] or numeric keys to set the value.
 Network Stack Configuration
Press [Enter] to go to 'Network Stack' screen to make further settings.
Network Stack
Use this item to enable or disable UEFI Network Stack.
The optional settings are: [Disabled]; [Enabled].
*When set as [Enabled], the following sub-items shall appear:
Ipv4 PXE Support
Use this item to enable IPv4 PXE boot support.
When set as [Disabled], IPv4 boot support will not be available.
The optional settings are: [Disabled]; [Enabled].
Ipv6 PXE Support
Use this item to enable IPv6 PXE boot support.
When set as [Disabled], IPv6 boot support will not be available.
The optional settings are: [Disabled]; [Enabled].
PXE boot wait time
Use this item to set wait time to press [ESC] key to abort the PXE boot.
Use either [+] / [-] or numeric keys to set the value.
Media Detect Count
Use this item to set number of times presence of media will be checked.
33