JETWAY MM10-H6100 Technical Manual page 29

The optional settings: [Disabled]; [Enabled].
Hot Plug
Use this item to designate this port as Hot Pluggable.
The optional settings: [Disabled]; [Enabled].
SATA3
Port
Use this item to enable or disable SATA port.
The optional settings: [Disabled]; [Enabled].
Hot Plug
Use this item to designate this port as Hot Pluggable.
The optional settings: [Disabled]; [Enabled].
SATA4
Port
Use this item to enable or disable SATA port.
The optional settings: [Disabled]; [Enabled].
Hot Plug
Use this item to designate this port as Hot Pluggable.
The optional settings: [Disabled]; [Enabled].
 PCH-FW Configuration
Press [Enter] to view Management Engine technology parameters and make
settings in the following sub-item:
TPM Device Selection
Use this item to select TPM device. When set as [PTT], it will enable PTT in
SkuMgr. When set as [dTPM], it will disable PTT in SkuMgr.
The optional settings: [dTPM]: [PTT].
Warning! PTT/dTPM will be disabled and all data saved on it will be lost.
I219 Lan MAC address Override
Use this item to enable for override MAC Address
The optional settings: [Disabled]; [Enabled].
 Firmware Update Configuration
Use this item to configure management engine Technology Parameter, press
[Enter] to make settings for 'ME FW Image Re-Flash'.
ME FW Image Re-Flash
Use this item to enable or disable ME FW Image Re-Flash function.
The optional settings: [Disabled]; [Enabled].
 AMT Configuration
Note: AMT configuration used by MM10-Q670
Use this item to configure Active Management Technology parameters.
Press [Enter] to make settings for the following sub-items:
USB Provisioning of AMT
Use this item to enable or disable AMT USB provisioning.
The optional settings are: [Disabled]; [Enabled].
25