JETWAY MM10-H6100 Technical Manual page 34

WatchDog Reset Timer
Use this item to enable or disable WDT reset function.
*When set as [Enabled], the following sub-items shall appear:
WatchDog Reset Timer Value
User can set a value in the range of [4] to [255].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select 'AT or ATX Mode' on MB jumper at first (refer to
JAT_ATX
jumper setting for Pin1&2 of ATX Mode & Pin 2&3 of AT Mode Select)
Case Open Detect
Use this item to detect Case has already open or not. Show message in POST.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will detect if COPEN has been short or not (refer
to COPEN jumper setting for Case Open Detection); if Pin 1&2 of CASE OPEN
are short, system will show Case Open Message during POST.
 PC Health Status
Press [Enter] to view current hardware health status, make further settings in
'SmartFAN Configuration' and set value in 'Shutdown Temperature'.
► SmartFAN Configuration
Press [Enter] to make settings for 'SmartFan Configuration':
SmartFAN Configuration
CPUFAN1 / SYSFAN1 / SYSFAN2 Smart Mode
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN1 / SYSFAN1 / SYSFAN2 Full-Speed Temperature
Use this item to set CPUFAN/SYSFAN1 full speed temperature. Fan will run at full
speed when above this pre-set temperature.
CPUFAN1 / SYSFAN1 / SYSFAN2 Full-Speed Duty
Use this item to set CPUFAN/SYSFAN1 full-speed duty. Fan will run at full speed
when above this pre-set duty.
CPUFAN1 / SYSFAN1 / SYSFAN2 Idle-Speed Temperature
Use this item to set CPUFAN/SYSFAN1 idle speed temperature. Fan will run at
idle speed when below this pre-set temperature.
CPUFAN1 / SYSFAN1 / SYSFAN2 Idle-Speed Duty
Use this item to set CPUFAN/SYSFAN1 idle speed duty. Fan will run at idle speed
when below this pre-set duty.
 Serial Port Console Redirection
COM1
Console Redirection
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
 Console Redirection Settings
The settings specify how the host computer and the remote computer (which the
30