Table of Contents
Advertisement
User level
Advanced user
Installer
Bürkert
8.7.7
Changing the operating state
Setting in the menu
Setting option:
Settings are executed on the PC using the büS service interface and the Bürkert Communicator
software. It requires the USB büS interface set available as an accessory.
Changing the operating state can be found in the
ration area.
In the
MANUAL
MODE
is also available for manual actuation of the valve.
For devices for which the actuator and housing are not yet screwed in place ex works, the MANUAL oper-
ating state is preset. For position or process control, the AUTO operating state is active.
8.8
Configuration management
The central configuration management makes the rapid replacement of Bürkert devices possible with no
configuration effort.
The central configuration management comprises a configuration provider which reads the configuration
from the configuration client and saves it centrally.
The configuration client settings are available in the following menu:
Menu: General settings →
Further information on the Configuration Client is described in the Software manual under
www.burkert.com → Central configuration management of Bürkert devices
38
Icon
Description
PIN required: Manufacturer-set code 005678
Rights: Reading values, limited right to change values.
PIN required. Manufacturer-set code 001946
Rights: reading values, expanded right to change values.
PIN required.
Only for Bürkert employees
AUTO / MANU
operating state - in addition to the menu
Parameters detailed viewed
english
menu in the General Settings configu-
AUTO / MANU
AUTO / MANU
→
Configuration Client
Type 3281
Start-up
- the menu
MANUAL
Advertisement
Table of Contents
