Gigaset Fusion Manual page 31

Talking with several participants on the telephone
Accepting/rejecting Call Waiting
The PABX or the provider supports this function and the function is activated on the
telephone.
Another call comes in during a conversation. The call is signalled in the display and by the Call
Waiting tone.
Accept a call:
Accept . . . The connection to the waiting participant is made. The first participant is put on
hold and hears some on-hold music.
Rejecting a call: Reject
End the call, resume the on-hold call:
Permit/prevent Call Waiting
When the function is enabled during a call, another incoming call is signalled by a call waiting
tone.
In display menu
Settings
see a list of set-up telephones
( = enabled)
In Web user interface
Settings
registered telephones are listed
( = enabled)
Set the Call Waiting tone (only for your device):
Select the required tone from the Ringtone list
Off
Single beep
Beep (every 4 sec.)
Save the settings:
Press the End call key
Telephony
Enable/disable Call Waiting for each device with the switch
Telephony Advanced settings
Enable/disable Call Waiting with the check box
There is no Call Waiting tone. A waiting call is only shown visually on
the display.
Call Waiting is indicated with a beep in the handset.
You can choose from various tone intervals.
Save
.
Call settings . . . Under Call waiting you will
Call waiting . . . In Call waiting the
Making calls
31