Gigaset Fusion Manual page 15

Setting up function keys
Function key From the Function list, select the required function
settings for the function key
General settings for function keys
Display name
Description of function key. This name is shown on the display on the function key.
Provisioning
Function keys can automatically be assigned via provisioning.
No Assign key manually. It is blocked from overwriting via provisioning.
Yes The key can be assigned via provisioning. Manual settings will be overwritten here.
LED Colour
You can select the LED colour for the BLF, Line and FAC function keys.
The LED is displayed on the function key with a coloured bar on the
left side.
Settings for function keys
BLF
(Busy Lamp Field)
Assigns an extension/telephone to the function key. All configured telephones are listed.
Select the extension from the Device list
Select LED Colour
The LED shows the status of the extension. Statuses when setting Default for the LED Colour
option:
Green Device is in idle mode / available.
Yellow An error has occurred.
Flashing red Incoming call.
Red The extension is engaged.
Quick dial
Assigns a number to the function key.
Select a connection to use to dial the number
If the entered number exists in a contact, the system copies the contact name as the
display name.
Line
Assigns a specific connection (line) to the function key. The key is used to initiate or accept a
call on this connection.
Select a connection
Select LED Colour
The LED shows the following statuses for Default setting:
Green The line is available.
Red The line is engaged.
Save
Enter the number
Getting to know your telephone
Configure further
SIP1
15