Commissioning - Bosch rexroth IH04E Assembly Instructions Manual

7 Commissioning

Leakage of hydraulic fluid due to incorrectly mounted press module type IH04E!
Danger to life! Risk of injury!
▶ Only commission your machine/system after all hydraulic connections and
the press module type IH04E have been completely and properly mounted
according to the specifications.
▶ Look out for defective sealing points and replace defective seal rings
immediately.
▶ Wear personal protective equipment during the initial commissioning.
Bursting of the press module type IH04E or ejection of the cap elements
due to inadmissible operating pressure!
Danger to life! Risk of injury! Danger of bursting!
▶ Before commissioning the hydraulic system, ensure that the maximum
admissible pressure of the hydraulic components in the machine/system
cannot be exceeded.
▶ Ensure that in your machine/system, the maximum admissible
operating pressure is secured by means of pressure limitation equipment.
Unintended downward movement due to oil loss through measuring point MX1,
MX1�1!
Danger to life! Risk of injury!
▶ Stay away from the danger zone if a hose or the like is attached to measuring
point MX1, MX1.1.
▶ After using the measuring point MX1, MX1.1, carefully check that it is tightly
closed and that the protective cap is reassembled.
Unintended downward movement due to oil loss through cylinder seals,
valves and fittings!
Danger to life! Risk of injury!
▶ Ensure that the retraction of the cylinder does not exceed 1 mm/s in normal
operation and 5 mm/s in the event of component failure.
▶ Always keep the time spent in the danger zone as short as possible.
▶ Always use a mechanical restraint device for all work.
Commissioning | Press module Type IH04E
WARNING
RE 63129-MON, Edition 09.2022, Bosch Rexroth AG
29/48